Base
N3657112026-10-28NY

RE: Country of origin determination for a screen system; 19 CFR 102.21(c)(2)

U.S. Customs and Border Protection · CROSS Database · 1 HTS code referenced

Summary

RE: Country of origin determination for a screen system; 19 CFR 102.21(c)(2)

Ruling Text

U.S. Department of Homeland Security U.S. Customs and Border Protection National Commodity Specialist Division One World Trade Center, Suite 51.201 New York, NY 10007 U.S. Customs and Border Protection N365711 October 28, 2026 OT:RR:NC:N3:351 CATEGORY: Origin Nigel Spork Centor North America Inc. 966-130 Corporate Boulevard Aurora, IL 60502 RE: Country of origin determination for a screen system; 19 CFR 102.21(c)(2) Dear Mr. Spork: In your letter, dated October 2, 2026, you requested a ruling on the country of origin of a screen system. A sample of the fabric and photographs of the item were provided with your request and will be retained for training purposes. Item #S7-D, described as a “S7 Insect Screen Double,” is a retractable double screen system designed to be permanently attached to a framed opening, such as a window or door opening and intended to protect the home against insects while allowing ventilation. The retractable screen system consists of an aluminum frame (head and sill components) and two screen assemblies. Each screen assembly consists of a mesh fabric attached to a roll tube fitted with cones and cables on one end and a handle pull bar attached to the other end. You state the fabric is composed of 72 percent polyvinyl chloride (PVC) and 28 percent polyester woven mesh fabric. Prior to weaving, the 100 percent polyester multifilament yarn is coated with PVC and treated for Ultraviolet (UV). Each screen assembly is attached to the aluminum frame on the left or right side and fully retracts while not in use for an unobstructed view. Each screen opens horizontally by gently pulling the pull bar to the desired position. To retract the screen, one pushes the pull bar to draw the mesh fabric back into the screen assembly. The insect screen double maximum frame height is 126 inches, frame width is 157 inches, and frame thickness is 2 inches. You also state that the screen system is imported to the United States in knock down condition and that it is a completely finished unit, packed with all components, ready to install in a window or door opening. You state the manufacturing operations for the screen system are as follows: Australia: • The plastic cones are produced and shipped to Poland. China: • The frame blocks, fixing screws, and stainless adjusting cone plate are produced and shipped to Poland. • The 100 percent polyester multifilament yarn is produced and shipped to the United States on spools. Germany: • The Centrack seam tape is produced and shipped to Poland. Spain: • The bearings are produced and shipped to Poland. Thailand: • The stainless-steel wire is produced and shipped to Poland. The United States: • The 100 percent polyester multifilament yarn is coated with PVC and UV. • The 72 percent PVC and 28 percent polyester mesh fabric is woven and shipped to Poland in rolls. • The springs and zinc coated copper crimp are manufactured and shipped to Poland. Poland: • The aluminum frame (head, sill jambs, and pull bar) and covers are produced. • The mesh fabric is cut to size. • All four sides of the mesh fabric are welded with the seam tape. • The mesh fabric is fitted to the roll tube and fixed in place ready for final assembly into the frame. • Aluminum is cut to length and predrilled for plastic frame blocks. • The mesh fabric is fitted with the cone and cable and installed into the frame together with the frame blocks. • All components are boxed and exported to the United States. ISSUE: What are the country of origin of the subject merchandise? COUNTRY OF ORIGIN - LAW AND ANALYSIS: Section 334 of the Uruguay Round Agreements Act (“URAA”) (codified at 19 U.S.C. 3592), enacted on December 8, 1994, provides the rules of origin for textiles and apparel products for purposes of the customs laws and the administration of quantitative restrictions, unless otherwise provided by the statute, entered, or withdrawn from warehouse, for consumption on or after July 1, 1996. Section 3592 has been described as Congress’s expression of substantial transformation as it relates to textile and apparel products. Section 102.21 of the Code of Federal Regulations (19 CFR 102.21), implements the URAA. The country of origin of a textile or apparel product shall be determined by the sequential application of the general rules set forth in paragraphs (c)(1) through (5) of section 102.21. See 19 CFR 102.21(c). Paragraph (c)(1) states, “The country of origin of a textile or apparel product is the single country, territory, or insular possession in which the good was wholly obtained or produced.” As the subject merchandise is not wholly obtained or produced in a single country, territory or insular possession, paragraph (c)(1) of Section 102.21 is inapplicable. Paragraph (c)(2) states, “Where the country of origin of a textile or apparel product cannot be determined under paragraph (c)(1) of this section, the country of origin of the good is the single country, territory, or insular possession in which each of the foreign materials incorporated in that good underwent an applicable change in tariff classification, and/or met any other requirement, specified for the good in paragraph (e) of this section:” Paragraph (e)(1) provides the rules used to determine the country of origin of a textile or apparel product under paragraph (c)(2) of this section. These rules are dependent on the classification of the good. The screen system is classified under subheading 6307.90.9891, Harmonized Tariff Schedule of the United States (HTSUS). Paragraph (e) in pertinent part states, HTSUS Tariff shift and/or other requirements 6307.90 The country of origin of a good classifiable under subheading 6307.90 is the country, territory, or insular possession in which the fabric comprising the good was formed by a fabric-making process. The “fabric-making process” is defined in 102.21(b)(2) as follows: A fabric-making process is any manufacturing operation that begins with polymers, fibers, filaments (including strips), yarns, twine, cordage, rope, or fabric strips and results in a textile fabric. As the fabric for the screen system is formed by the fabric-making process in a single country, that is, the United States, as per the terms of the tariff shift requirement, the country of origin for the screen system is conferred in the United States. Inasmuch as the marking requirements of 19 U.S.C. 1304 are applicable only to articles of “foreign origin,” the subject screen systems are not required to be marked upon importation into the United States. Whether an article may be marked with the phrase “Made in the USA” or similar words denoting U.S. origin, is an issue under the authority of the Federal Trade Commission (FTC). We suggest that you contact the FTC Division of Enforcement, 600 Pennsylvania Avenue, N.W., Washington, D.C. 20580 on the propriety of proposed markings indicating that an article is made in the U.S. Information can also be found at the FTC website www.ftc.gov. HOLDING: The country of origin of the screen system is the United States pursuant to 19 CFR 102.21(c)(2). The holding set forth above applies only to the specific factual situation and merchandise description as identified in the ruling request. This position is clearly set forth in Title 19, Code of Federal Regulations (CFR), Section 177.9(b)(1). This section states that a ruling letter is issued on the assumption that all of the information furnished in the ruling letter, whether directly, by reference, or by implication, is accurate and complete in every material respect. In the event that the facts are modified in any way, or if the goods do not conform to these facts at time of importation, you should bring this to the attention of U.S. Customs and Border Protection (CBP) and submit a request for a new ruling in accordance with 19 CFR 177.2. Additionally, we note that the material facts described in the foregoing ruling may be subject to periodic verification by CBP. This ruling is being issued under the provisions of Part 177 of the Customs and Border Protection Regulations (19 C.F.R. 177). A copy of the ruling or the control number indicated above should be provided with the entry documents filed at the time this merchandise is imported. If you have any questions regarding the ruling, please contact National Import Specialist Kristine Dodge at kristine.dodge@cbp.dhs.gov. Sincerely, (for) James P. Forkan Director National Commodity Specialist Division

Related Rulings for HTS 6307.90

Other CBP classification decisions referencing the same tariff code.

Court of International Trade & Federal Circuit (5)

CIT and CAFC court opinions related to the tariff classifications in this ruling.