Transportation Department, Federal Aviation Administration
The FAA proposes to supersede Airworthiness Directive (AD) 2024-19-14, which applies to certain The Boeing Company Model 777-200, 777-200LR, 777-300, 777-300ER, and 777F series airplanes. AD 2024-19-14 requires repetitive inspections and bond resistance measurement of the bonding jumpers on the first fuel feed tube installed immediately forward of the wing front spar at the left and right main fuel tank penetrations, and applicable corrective actions. Since the FAA issued AD 2024-19-14, the FAA determined that additional inspections are required to address the unsafe condition. This proposed AD would require repetitive detailed inspections (DET), repetitive bond resistance measurement, and applicable on-condition actions. This proposed AD would also expand the applicability and require revising the existing maintenance or inspection program, as applicable, to incorporate a certain airworthiness limitation. The FAA is proposing this AD to address the unsafe condition on these products.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2025-2546; Project Identifier AD-2025-01060-T] RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Notice of proposed rulemaking (NPRM). SUMMARY: The FAA proposes to supersede Airworthiness Directive (AD) 2024-19-14, which applies to certain The Boeing Company Model 777-200, 777-200LR, 777-300, 777-300ER, and 777F series airplanes. AD 2024-19-14 requires repetitive inspections and bond resistance measurement of the bonding jumpers on the first fuel feed tube installed immediately forward of the wing front spar at the left and right main fuel tank penetrations, and applicable corrective actions. Since the FAA issued AD 2024-19-14, the FAA determined that additional inspections are required to address the unsafe condition. This proposed AD would require repetitive detailed inspections (DET), repetitive bond resistance measurement, and applicable on-condition actions. This proposed AD would also expand the applicability and require revising the existing maintenance or inspection program, as applicable, to incorporate a certain airworthiness limitation. The FAA is proposing this AD to address the unsafe condition on these products. DATES: The FAA must receive comments on this proposed AD by October 30, 2025. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45 , by any of the following methods: Federal eRulemaking Portal: Go to regula…
Other Federal Register documents from the same docket.
Citation: 90 FR 44340
