Transportation Department, Federal Aviation Administration
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus Helicopters Deutschland GmbH Model EC135P1, EC135P2, EC135P2+, EC135P3, EC135T1, EC135T2, EC135T2+, EC135T3, EC635T2+, MBB- BK 117 C-2, MBB-BK 117 D-2, and MBB-BK 117 D-3 helicopters. This proposed AD was prompted by a review of design data and the determination for recalculation of accumulated hoist boom cycles (cycles) and repetitive inspections. This proposed AD would require determining the total cycles of certain hoist boom assemblies, inspecting those hoist boom assemblies, and depending on the results, taking corrective action. This proposed AD would also prohibit installing those hoist boom assemblies unless certain requirements are met. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2025-0630; Project Identifier MCAI-2023-00518-R] RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Notice of proposed rulemaking (NPRM). SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus Helicopters Deutschland GmbH Model EC135P1, EC135P2, EC135P2+, EC135P3, EC135T1, EC135T2, EC135T2+, EC135T3, EC635T2+, MBB-BK 117 C-2, MBB-BK 117 D-2, and MBB-BK 117 D-3 helicopters. This proposed AD was prompted by a review of design data and the determination for recalculation of accumulated hoist boom cycles (cycles) and repetitive inspections. This proposed AD would require determining the total cycles of certain hoist boom assemblies, inspecting those hoist boom assemblies, and depending on the results, taking corrective action. This proposed AD would also prohibit installing those hoist boom assemblies unless certain requirements are met. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products. DATES: The FAA must receive comments on this NPRM by June 9, 2025. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45 , by any of the following methods: Federal eRulemaking Portal: Go to regulations.gov. Follow the instructions for submitting comments. Fax: (20…
Other Federal Register documents from the same docket.
Citation: 90 FR 17348
