Classification and country of origin determination for a men’s reversible jacket; 19 CFR 102.21(c)(4)

NY G80563 September 5, 2000 CLA2-RR:NC:TA:357 G80563 CATEGORY: Classification Mr. Thomas G. Travis Sandler, Travis & Rosenberg, P.A. 5200 Blue Lagoon Drive Miami, FL33126-2022 RE: Classification and country of origin determination for a men’s reversible jacket; 19 CFR 102.21(c)(4) Dear Mr. Travis: This is in reply to your letter dated August 10, 2000, on behalf of the Textile Council of Hong Kong, requesting a classification and country of origin determination for a men’s jacket which will be imported into the United States. Samples were submitted and are being returned as you requested. Due to possible changes in production countries, the countries where the processing will take place are designated countries ‘A’ and ‘B’. Israel will not be among the countries involved. FACTS: The subject merchandise consists of style #18, a men’s reversible jacket. One side is made from a woven 70% cotton/30% nylon fabric that is visibly coated with polyurethane on its inner surface, and the other side is made from a knit 100% polyester fleece fabric. The jacket has long sleeves with elasticized cuffs, an integral hood, an elasticized drawcord through the bottom hem and a full-front opening with a zipper closure featuring a reversible pull. On each side there are slant pockets at the waist, with the woven side pockets having zipper closures and the knit side pockets having VELCRO-type closures. The woven side also has a zippered pocket on the left chest, a locker loop and a sewn-on logo above the chest pocket. The knit side has the word “Hilfiger” embroidered in large letters across the back and in small letters with a large “H” on the left chest. The manufacturing operations for the jacket are as follows: Korea: Seventy percent cotton/30% nylon fabric is woven and coated with polyurethane Taiwan: One hundred percent polyester woven fabric One hundred percent polyester knit fabric Hong Kong: Trim items are sourced: Nonwoven fusible interlining Zipper Woven patch Drawcord Stopper Eyelet Nylon tape Woven zipper pull Velcro Elastic Sewing thread Labels Manufacturing Steps Country ‘A’: Fabric is cut into component parts Interlining fused Woven zipper pull attached to zipper Woven patch sewn to front panel shell Sewing of embroidery to reverse shell Setting of pockets to front panels of shell and reverse shell Setting of eyelet, drawcord and stopper Setting of zipper along center front Tacking of panels at hem Tacking of sleeve panels at cuff Joining of hood panels to form hood Country ‘B’: Joining of front and back panels at shoulder Joining of side seams Setting of elastic at cuff edge Setting of sleeve panels to body at armholes Setting of hood to body along neckline Sewing labels onto jacket Country ‘A’: Thread trimming Ironing Hangtags attached Packing Packaging ISSUE: What are the classification and country of origin of the subject merchandise? CLASSIFICATION: The applicable subheading for the jacket will be 6210.40.9025, Harmonized Tariff Schedule of the United States Annotated (HTSUSA), which provides for other men’s or boys’ garments made up of fabrics of heading 5602, 5603, 5903, 5906 or 5907, other than of man-made fibers: anoraks (including ski-jackets), windbreakers and similar articles. The rate of duty will be 6.4 percent ad valorem. This jacket falls within textile category designation 334. The designated textile and apparel categories and their quota and visa status are the result of international agreements that are subject to frequent renegotiations and changes. To obtain the most current information, we suggest that you check, close to the time of shipment, the U.S. Customs Service Textile Status Report, an internal issuance of the U.S. Customs Service, which is available at the Customs Web Site at WWW.CUSTOMS.GOV. In addition, the designated textile and apparel categories may be subdivided into parts. If so, visa and quota requirements applicable to the subject merchandise may be affected and should also be verified at the time of shipment. COUNTRY OF ORIGIN - LAW AND ANALYSIS: On December 8, 1994, the President signed into law the Uruguay Round Agreements Act. Section 334 of that Act (codified at 19 U.S.C. 3592) provides new rules of origin for textiles and apparel entered, or withdrawn from warehouse, for consumption, on and after July 1, 1996. On September 5, 1995, Customs published Section 102.21, Customs Regulations, in the Federal Register, implementing Section 334 (60 FR 46188). Thus, effective July 1, 1996, the country of origin of a textile or apparel product shall be determined by sequential application of the general rules set forth in paragraphs (c)(1) through (5) of Section 102.21. Paragraph (c)(1) states that "The country of origin of a textile or apparel product is the single country, territory, or insular possession in which the good was wholly obtained or produced." As the subject merchandise is not wholly obtained or produced in a single country, territory or insular possession, paragraph (c)(1) of Section 102.21 is inapplicable. Paragraph (c)(2) states that "Where the country of origin of a textile or apparel product cannot be determined under paragraph (c)(1) of this section, the country of origin of the good is the single country, territory, or insular possession in which each of the foreign materials incorporated in that good underwent an applicable change in tariff classification, and/or met any other requirement, specified for the good in paragraph (e) of this section:" Paragraph (e) in pertinent part states that "The following rules shall apply for purposes of determining the country of origin of a textile or apparel product under paragraph (c)(2) of this section": HTSUS Tariff shift and/or other requirements 6201-6208 If the good consists of two or more component parts, a change to an assembled good of heading 6201 through 6208 from unassembled components, provided that the change is the result of the good being wholly assembled in a single country, territory, or insular possession. As the subject merchandise is not wholly assembled in a single country, territory, or insular possession, the terms of the tariff shift are not met. Section 102.21(c)(3) states that, "Where the country of origin of a textile or apparel product cannot be determined under paragraph (c)(1) or (2) of this section": (i) If the good was knit to shape, the country of origin of the good is the single country, territory, or insular possession in which the good was knit; or (ii) Except for goods of heading 5609, 5807, 5811, 6213, 6214, 6301 through 6306, and 6308, and subheadings 6209.20.5040, 6307.10, 6307.90, and 9404.90, if the good was not knit to shape and the good was wholly assembled in a single country, territory, or insular possession, the country of origin of the good is the country, territory, or insular possession in which the good was wholly assembled. As the subject merchandise is neither knit, nor wholly assembled in a single country, Section 102.21 (c)(3) is inapplicable. Section 102.21 (c)(4) states, "Where the country of origin of a textile or apparel product cannot be determined under paragraph (c)(1), (2) or (3) of this section, the country of origin of the good is the single country, territory or insular possession in which the most important assembly or manufacturing process occurred". In the case of the subject merchandise, the joining of the front and back panels at the shoulder and side seams, the setting of the sleeve panels to the body at the armholes and the setting of the hood to the body along the neckline constitute the most important assembly processes. Accordingly, the country of origin of the jacket is Country ‘B’. HOLDING: The country of origin of the jacket is Country ‘B’. Based upon international textile trade agreements products of various countries are subject to quota and the requirement of a visa. The holding set forth above applies only to the specific factual situation and merchandise identified in the ruling request. This position is clearly set forth in section 19 CFR 177.9(b)(1). This section states that a ruling letter, either directly, by reference, or by implication, is accurate and complete in every material respect. This ruling is being issued under the provisions of Part 177 of the Customs Regulations (19 C.F.R. 177). Should it be subsequently determined that the information furnished is not complete and does not comply with 19 CFR 177.9(b)(1), the ruling will be subject to modification or revocation. In the event there is a change in the facts previously furnished, this may affect the determination of country of origin. Accordingly, if there is any change in the facts submitted to Customs, it is recommended that a new ruling request be submitted in accordance with 19 CFR 177.2. A copy of the ruling or the control number indicated above should be provided with the entry documents filed at the time this merchandise is imported. If you have any questions regarding the ruling, contact National Import Specialist W. Raftery at 212-637-7076. Sincerely, Robert B. Swierupski Director, National Commodity Specialist Division