Transportation Department, Federal Aviation Administration
The FAA proposes to supersede Airworthiness Directive (AD) 2022-25-05, which applies to certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500-1A11 airplanes. AD 2022-25-05 requires repetitive cleaning and greasing of all slat tracks to prevent damage or corrosion; doing repetitive inspections of the slat tracks for any damage or corrosion, and the correct application of grease; and applicable corrective actions. Since the FAA issued AD 2022-25-05, it has been discovered that previous slat track repairs required the use of inappropriate non-destructive test (NDT) methods and, therefore, may have allowed cracks to remain undetected on slat tracks that were previously repaired. This proposed AD would continue to require the actions in AD 2022-25-05 and would require a rework NDT inspection on all slat tracks previously repaired using an inappropriate NDT method. The FAA is proposing this AD to address the unsafe condition on these products.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2026-4634; Project Identifier MCAI-2024-00508-T] RIN 2120-AA64 ( printed page 25809) AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Notice of proposed rulemaking (NPRM). SUMMARY: The FAA proposes to supersede Airworthiness Directive (AD) 2022-25-05, which applies to certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500-1A11 airplanes. AD 2022-25-05 requires repetitive cleaning and greasing of all slat tracks to prevent damage or corrosion; doing repetitive inspections of the slat tracks for any damage or corrosion, and the correct application of grease; and applicable corrective actions. Since the FAA issued AD 2022-25-05, it has been discovered that previous slat track repairs required the use of inappropriate non-destructive test (NDT) methods and, therefore, may have allowed cracks to remain undetected on slat tracks that were previously repaired. This proposed AD would continue to require the actions in AD 2022-25-05 and would require a rework NDT inspection on all slat tracks previously repaired using an inappropriate NDT method. The FAA is proposing this AD to address the unsafe condition on these products. DATES: The FAA must receive comments on this proposed AD by June 26, 2026. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45 , by any of the following methods: Federal eRulemaking Portal: Go to regulations.gov …
Citation: 91 FR 25809
