Transportation Department, Federal Aviation Administration
The FAA is adopting a new airworthiness directive (AD) for all DG Aviation GmbH (Type Certificate Previously Held by DG Flugzeugbau GmbH) Model DG-1000M gliders. This AD was prompted by reports of engine mount cracking near the propeller head. This AD requires updating the maintenance manual, inspecting the engine mount for cracks, and taking corrective actions if cracks are found. This AD also requires performing a powerplant belt tension inspection and, depending on the results of the inspection, adjusting the belt tension. This AD also requires balancing the propeller assembly and installing a carbon fiber reinforced plastic (CFRP) bracket. This AD also prohibits accomplishing certain maintenance actions in the maintenance manual. The FAA is issuing this AD to address the unsafe condition on these products.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2026-2727; Project Identifier MCAI-2025-00685-G; Amendment 39-23298; AD 2026-07-03] RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Final rule; request for comments. SUMMARY: The FAA is adopting a new airworthiness directive (AD) for all DG Aviation GmbH (Type Certificate Previously Held by DG Flugzeugbau GmbH) Model DG-1000M gliders. This AD was prompted by reports of engine mount cracking near the propeller head. This AD requires updating the maintenance manual, inspecting the engine mount for cracks, and taking corrective actions if cracks are found. This AD also requires performing a powerplant belt tension inspection and, depending on the results of the inspection, adjusting the belt tension. This AD also requires balancing the propeller assembly and installing a carbon fiber reinforced plastic (CFRP) bracket. This AD also prohibits accomplishing certain maintenance actions in the maintenance manual. The FAA is issuing this AD to address the unsafe condition on these products. DATES: This AD is effective April 20, 2026. The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of April 20, 2026. The FAA must receive comments on this AD by May 18, 2026. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45 , by any of the following methods: Federal eRulemaking…
Citation: 91 FR 16815
