Transportation Department, Federal Aviation Administration
The FAA proposes to adopt a new airworthiness directive (AD) for certain Ontic Engineering and Manufacturing, Inc. Model SA226-T, SA226-AT, SA226-T(B), SA226-TC, SA227-AC (C-26A), SA227-AT, SA227-BC (C-26A), SA227-CC, SA227-DC (C-26B), and SA-227-TT (300) airplanes. This proposed AD was prompted by reports of in-flight pitch trim actuator failures. This proposed AD would require repetitively inspecting the pitch trim actuator for cracked, missing, or compromised sealant, replacing and sealing the pitch trim actuator if cracked, missing, or compromised, repetitively measuring the pitch trim actuator travel time, and depending on the results of the measurements, replacing and sealing the pitch trim actuator. This proposed AD would prohibit the installation of certain pitch trim actuators unless the pitch trim actuator is sealed. The FAA is proposing this AD to address the unsafe condition on these products.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2026-2723; Project Identifier AD-2024-00429-A] RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Notice of proposed rulemaking (NPRM). SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD) for certain Ontic Engineering and Manufacturing, Inc. Model SA226-T, SA226-AT, SA226-T(B), SA226-TC, SA227-AC (C-26A), SA227-AT, SA227-BC (C-26A), SA227-CC, SA227-DC (C-26B), and SA-227-TT (300) airplanes. This proposed AD was prompted by reports of in-flight pitch trim actuator failures. This proposed AD would require repetitively inspecting the pitch trim actuator for cracked, missing, or compromised sealant, replacing and sealing the pitch trim actuator if cracked, missing, or compromised, repetitively measuring the pitch trim actuator travel time, and depending on the results of the measurements, replacing and sealing the pitch trim actuator. This proposed AD would prohibit the installation of certain pitch trim actuators unless the pitch trim actuator is sealed. The FAA is proposing this AD to address the unsafe condition on these products. DATES: The FAA must receive comments on this proposed AD by May 18, 2026. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45 , by any of the following methods: Federal eRulemaking Portal: Go to regulations.gov . Follow the instructions for submitting comments. Fax: (202) 493-2251. Mai…
Citation: 91 FR 16595
