Transportation Department, Federal Aviation Administration
The FAA proposes to supersede Airworthiness Directive (AD) 2025-06-04, which applies to all Airbus Helicopters Model AS350B, AS350B1, AS350B2, AS350B3, AS350BA, AS350D, AS355E, AS355F, AS355F1, AS355F2, AS355N, AS355NP, EC130B4, and EC130T2 helicopters. AD 2025-06-04 requires repetitively inspecting the main gearbox (MGB) bevel wheel and the MGB magnetic plug for particles and performing corrective actions if applicable and prohibits installing an affected MGB unless certain requirements are met. Since the FAA issued AD 2025-06-04, the FAA determined that AD 2025-06-04 contains errors in the interval compliance times. This proposed AD would continue to require the actions of AD 2025-06-04 and revise the interval compliance times. The FAA is proposing this AD to address the unsafe condition on these products.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2025-5032; Project Identifier AD-2025-01042-R] RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Notice of proposed rulemaking (NPRM). SUMMARY: The FAA proposes to supersede Airworthiness Directive (AD) 2025-06-04, which applies to all Airbus Helicopters Model AS350B, AS350B1, AS350B2, AS350B3, AS350BA, ( printed page 53239) AS350D, AS355E, AS355F, AS355F1, AS355F2, AS355N, AS355NP, EC130B4, and EC130T2 helicopters. AD 2025-06-04 requires repetitively inspecting the main gearbox (MGB) bevel wheel and the MGB magnetic plug for particles and performing corrective actions if applicable and prohibits installing an affected MGB unless certain requirements are met. Since the FAA issued AD 2025-06-04, the FAA determined that AD 2025-06-04 contains errors in the interval compliance times. This proposed AD would continue to require the actions of AD 2025-06-04 and revise the interval compliance times. The FAA is proposing this AD to address the unsafe condition on these products. DATES: The FAA must receive comments on this proposed AD by January 9, 2026. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45 , by any of the following methods: Federal eRulemaking Portal: Go to regulations.gov. Follow the instructions for submitting comments. Fax: (202) 493-2251. Mail: U.S. Department of Transportation, Docket Operations, M-30, West Buildin…
Other Federal Register documents from the same docket.
Citation: 90 FR 53238
