Transportation Department, Federal Aviation Administration
The FAA proposes to adopt a new airworthiness directive (AD) for certain Pratt & Whitney (PW) Model F117-PW-100, PW2037, PW2037D, PW2037M, PW2040, PW2040D, PW2043, PW2143, and PW2643 engines. This proposed AD was prompted by an updated analysis of an event involving an International Aero Engines, LLC (IAE LLC) Model PW1127GA-JM engine, which experienced a high-pressure compressor (HPC) 7th-stage integrally bladed rotor (IBR-7) separation that resulted in an engine shutdown and aborted takeoff. This proposed AD would require repetitive angled ultrasonic inspections (AUSIs) of certain high-pressure turbine (HPT) 1st-stage disks and turbine hubs for any crack indications, and if necessary, removal from service and replacement, and removal from service of certain HPT lenticular seal assemblies. The FAA is proposing this AD to address the unsafe condition on these products.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2025-0918; Project Identifier AD-2024-00526-E] RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Notice of proposed rulemaking (NPRM). SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD) for certain Pratt & Whitney (PW) Model F117-PW-100, PW2037, PW2037D, PW2037M, PW2040, PW2040D, PW2043, PW2143, and PW2643 engines. This proposed AD was prompted by an updated analysis of an event involving an International Aero Engines, LLC (IAE LLC) Model PW1127GA-JM engine, which experienced a high-pressure compressor (HPC) 7th-stage integrally bladed rotor (IBR-7) separation that resulted in an engine shutdown and aborted takeoff. This proposed AD would require repetitive angled ultrasonic inspections (AUSIs) of certain high-pressure turbine (HPT) 1st-stage disks and turbine hubs for any crack indications, and if necessary, removal from service and replacement, and removal from service of certain HPT lenticular seal assemblies. The FAA is proposing this AD to address the unsafe condition on these products. DATES: The FAA must receive comments on this proposed AD by July 17, 2025. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45 , by any of the following methods: Federal eRulemaking Portal: Go to regulations.gov . Follow the instructions for submitting comments. Fax: (202) 493-2251. Mail: U.S. Department of Transporta…
Other Federal Register documents from the same docket.
Citation: 90 FR 23294
