Transportation Department, Federal Aviation Administration
The FAA is revising a notice of proposed rulemaking (NPRM) that applied to all airplanes with certain Pacific Scientific Company rotary buckle assemblies (buckles) installed. This action revises the NPRM by expanding the applicability and updating the referenced material. As an option to the actions proposed by this SNPRM, this SNPRM would allow removing the male side from the lap of the restraint system assembly and installing a placard stating that use of the seat is prohibited; use of that crewmember seat or passenger seat would then be prohibited until the actions proposed by this SNPRM are accomplished and the male side from the lap of the restraint system assembly is reinstalled. The NPRM was prompted by a report of a manufacturing defect in the screws used inside the buckle; this SNPRM is prompted by the discovery that additional screws are affected by the unsafe condition. The FAA is proposing this airworthiness directive (AD) to address the unsafe condition on these products. Since these actions would impose an additional burden over that in the NPRM, the FAA is requesting comments on this SNPRM.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2024-0230; Project Identifier AD-2023-01064-A,Q,T] RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Supplemental notice of proposed rulemaking (SNPRM). SUMMARY: The FAA is revising a notice of proposed rulemaking (NPRM) that applied to all airplanes with certain Pacific Scientific Company rotary buckle assemblies (buckles) installed. This action revises the NPRM by expanding the applicability and updating the referenced material. As an option to the actions proposed by this SNPRM, this SNPRM would allow removing the male side from the lap of the restraint system assembly and installing a placard stating that use of the seat is prohibited; use of that crewmember seat or passenger seat would then be prohibited until the actions proposed by this SNPRM are accomplished and the male side from the lap of the restraint system assembly is reinstalled. The NPRM was prompted by a report of a manufacturing defect in the screws used inside the buckle; this SNPRM is prompted by the discovery that additional screws are affected by the unsafe condition. The FAA is proposing this airworthiness directive (AD) to address the unsafe condition on these products. Since these actions would impose an additional burden over that in the NPRM, the FAA is requesting comments on this SNPRM. ( printed page 9294) DATES: The FAA must receive comments on this SNPRM by March 28, 2025. ADDRESSE…
Other Federal Register documents from the same docket.
Citation: 90 FR 9293
