Transportation Department, Federal Aviation Administration
The FAA proposes to adopt a new airworthiness directive (AD) for all International Aero Engines, LLC (IAE LLC) Model PW1122G-JM, PW1124G1-JM, PW1124G-JM, PW1127G1-JM, PW1127G1A-JM, PW1127G1B-JM, PW1127G-JM, PW1127GA-JM, PW1129G-JM, PW1130G-JM, PW1133G-JM, and PW1133GA-JM engines. This proposed AD was prompted by an in-flight shutdown (IFSD) caused by the fracture of a low-pressure compressor (LPC) 1st-stage integrally bladed rotor (IBR-1). This proposed AD would require removal and replacement of affected LPC key washers and affected LPC IBR-1 and installation of inlet guide vane (IGV) spacers. The FAA is proposing this AD to address the unsafe condition on these products.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2024-0763; Project Identifier AD-2023-00924-E] RIN 2120-AA64 ( printed page 20551) AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Notice of proposed rulemaking (NPRM). SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD) for all International Aero Engines, LLC (IAE LLC) Model PW1122G-JM, PW1124G1-JM, PW1124G-JM, PW1127G1-JM, PW1127G1A-JM, PW1127G1B-JM, PW1127G-JM, PW1127GA-JM, PW1129G-JM, PW1130G-JM, PW1133G-JM, and PW1133GA-JM engines. This proposed AD was prompted by an in-flight shutdown (IFSD) caused by the fracture of a low-pressure compressor (LPC) 1st-stage integrally bladed rotor (IBR-1). This proposed AD would require removal and replacement of affected LPC key washers and affected LPC IBR-1 and installation of inlet guide vane (IGV) spacers. The FAA is proposing this AD to address the unsafe condition on these products. DATES: The FAA must receive comments on this proposed AD by May 9, 2024. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45 , by any of the following methods: Federal eRulemaking Portal: Go to regulations.gov . Follow the instructions for submitting comments. Fax: (202) 493-2251. Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590. Hand Delivery: Deliver to Mail address above between 9 a.m. an…
Other Federal Register documents from the same docket.
Citation: 89 FR 20551
