Transportation Department, Federal Aviation Administration
This amendment rescinds Airworthiness Directive (AD) 98-16-17 R1, which is applicable to all Cessna Model 750 Citation X series airplanes. That AD requires repetitive in-flight functional tests to verify proper operation of the secondary horizontal stabilizer pitch trim system, and repair if necessary. The requirements of that AD were intended to detect and correct contamination and damage in the system actuator, which could result in simultaneous failure of both primary and secondary pitch trim systems, and consequent reduced controllability of the airplane. Since the issuance of that AD, an improved part has been developed, which, if installed, would terminate the repetitive tests; that improved part has been installed on all affected airplanes or is being installed in production. Therefore, the identified unsafe condition no longer exists.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. 99-NM-229-AD; Amendment 39-13347; AD 98-16-17 R1] RIN 2120-AA64 AGENCY: Federal Aviation Administration, DOT. ACTION: Final rule; rescission. SUMMARY: This amendment rescinds Airworthiness Directive (AD) 98-16-17 R1, which is applicable to all Cessna Model 750 Citation X series airplanes. That AD requires repetitive in-flight functional tests to verify proper operation of the secondary horizontal stabilizer pitch trim system, and repair if necessary. The requirements of that AD were intended to detect and correct contamination and damage in the system actuator, which could result in simultaneous failure of both primary and secondary pitch trim systems, and consequent reduced controllability of the airplane. Since the issuance of that AD, an improved part has been developed, which, if installed, would terminate the repetitive tests; that improved part has been installed on all affected airplanes or is being installed in production. Therefore, the identified unsafe condition no longer exists. EFFECTIVE DATE: October 23, 2003. FOR FURTHER INFORMATION CONTACT: Joel M. Ligon, Aerospace Engineer, Systems and Propulsion Branch, ACE-116W, FAA, Small Airplane Directorate, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas 67209; telephone (316) 946-4138; fax (316) 946-4407. SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal …
Other Federal Register documents from the same docket.
Citation: 68 FR 60624
