Classification and country of origin determination for coveralls cut to shape in India and assembled in the United States; 19 CFR 102.21(c)(2); tariff shift

N016937 September 18, 2007 CLA2-RR:NC:3:353 CATEGORY: Classification Mr. Cal Kalwani Just In Trend 6900 Capital View Ct. Johnston, IA 50131 RE: Classification and country of origin determination for coveralls cut to shape in India and assembled in the United States; 19 CFR 102.21(c)(2); tariff shift Dear Mr. Kalwani: This is in reply to your letter dated September 5, 2007, requesting a classification and country of origin determination for coveralls cut to shape in India and assembled in the United States. FACTS: The subject merchandise consists of woven coveralls of yet to be determined fiber content. Four coverall components, the upper torso, left arm, right arm and bottom half will be cut to shape in India and imported into the United States where the components will be assembled into a coverall. ISSUE: What are the classification and country of origin of the subject merchandise? CLASSIFICATION: The applicable subheading for the coveralls will be 6211.32 through 6211.49, Harmonized Tariff Schedule of the United States (HTSUS), which provides for other garments. COUNTRY OF ORIGIN - LAW AND ANALYSIS: Section 334 of the Uruguay Round Agreements Act (codified at 19 U.S.C. 3592), enacted on December 8, 1994, provided rules of origin for textiles and apparel entered, or withdrawn from warehouse for consumption, on and after July 1, 1996. Section 102.21, Customs Regulations (19 C.F.R. 102.21), published September 5, 1995 in the Federal Register, implements Section 334 (60 FR 46188). Section 334 of the URAA was amended by section 405 of the Trade and Development Act of 2000, enacted on May 18, 2000, and accordingly, section 102.21 was amended (68 Fed. Reg. 8711). Thus, the country of origin of a textile or apparel product shall be determined by the sequential application of the general rules set forth in paragraphs (c)(1) through (5) of Section 102.21. Paragraph (c)(1) states, “The country of origin of a textile or apparel product is the single country, territory, or insular possession in which the good was wholly obtained or produced.” As the subject merchandise is not wholly obtained or produced in a single country, territory or insular possession, paragraph (c)(1) of Section 102.21 is inapplicable. Paragraph (c)(2) states, “Where the country of origin of a textile or apparel product cannot be determined under paragraph (c)(1) of this section, the country of origin of the good is the single country, territory, or insular possession in which each of the foreign materials incorporated in that good underwent an applicable change in tariff classification, and/or met any other requirement, specified for the good in paragraph (e) of this section:” Paragraph (e) in pertinent part states, The following rules shall apply for purposes of determining the country of origin of a textile or apparel product under paragraph (c)(2) of this section: HTSUS Tariff shift and/or other requirements 6210-6212 (1) If the good consists of two or more component parts, a change to an assembled good of heading 6210 through 6212 from unassembled components, provided that the change is the result of the good being wholly assembled in a single country, territory, or insular possession. As the coveralls consist of two or more components parts and are assembled in a single country, that is, the United States, as per the terms of the tariff shift requirement, country of origin is conferred in the United States. HOLDING: The country of origin of the coveralls is the United Sates. You inquire as to whether the finished coveralls can be labeled “Made in USA” or “Assembled in USA.” If a good is determined to be an article of U.S. origin, it is not subject to the country of origin marking requirements of 19 U.S.C. §1304. Whether an article may be marked with the phrase "Made in the USA" or similar words denoting U.S. origin, is an issue under the authority of the Federal Trade Commission (FTC). We suggest that you contact the FTC Division of Enforcement, 600 Pennsylvania Avenue, N.W., Washington, D.C. 20580 on the propriety of proposed markings indicating that an article is made in the U.S. The holding set forth above applies only to the specific factual situation and merchandise identified in the ruling request. This position is clearly set forth in section 19 CFR 177.9(b)(1). This section states that a ruling letter, either directly, by reference, or by implication, is accurate and complete in every material respect. This ruling is being issued under the provisions of Part 177 of the Customs Regulations (19 C.F.R. 177). Should it be subsequently determined that the information furnished is not complete and does not comply with 19 CFR 177.9(b)(1), the ruling will be subject to modification or revocation. In the event there is a change in the facts previously furnished, this may affect the determination of country of origin. Accordingly, if there is any change in the facts submitted to Customs, it is recommended that a new ruling request be submitted in accordance with 19 CFR 177.2. A copy of the ruling or the control number indicated above should be provided with the entry documents filed at the time this merchandise is imported. If you have any questions regarding the ruling, contact National Import Specialist Kenneth Reidlinger at 646-733-3053. Sincerely, Robert B. Swierupski Director, National Commodity Specialist Division