Transportation Department, Federal Aviation Administration
The FAA is adopting a new airworthiness directive (AD) for certain CFM International, S.A. (CFM) Model LEAP-1A23, LEAP-1A24, LEAP- 1A24E1, LEAP-1A26, LEAP-1A26CJ, LEAP-1A26E1, LEAP-1A29, LEAP-1A29CJ, LEAP-1A30, LEAP-1A32, LEAP-1A33, LEAP-1A33B2, and LEAP-1A35A engines. This AD was prompted by reports of two in-flight shutdowns and subsequent investigation by the manufacturer that revealed cracks in the high-pressure turbine (HPT) rotor stage 1 blades. This AD requires initial and repetitive borescope inspections (BSIs) of the HPT rotor stage 1 blades. Depending on the results of the BSIs, this AD requires either additional BSIs at reduced intervals or replacement of the HPT rotor stage 1 blades. The FAA is issuing this AD to address the unsafe condition on these products.
Document Headings Document headings vary by document type but may contain the following: the agency or agencies that issued and signed a document the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to the agency docket number / agency internal file number the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2025-3434; Project Identifier AD-2025-00473-E; Amendment 39-23175; AD 2025-21-03] RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Final rule; request for comments. SUMMARY: The FAA is adopting a new airworthiness directive (AD) for certain CFM International, S.A. (CFM) Model LEAP-1A23, LEAP-1A24, LEAP-1A24E1, LEAP-1A26, LEAP-1A26CJ, LEAP-1A26E1, LEAP-1A29, LEAP-1A29CJ, LEAP-1A30, LEAP-1A32, LEAP-1A33, LEAP-1A33B2, and LEAP-1A35A engines. This AD was prompted by reports of two in-flight shutdowns and subsequent investigation by the manufacturer that revealed cracks in the high-pressure turbine (HPT) rotor stage 1 blades. This AD requires initial and repetitive borescope inspections (BSIs) of the HPT rotor stage 1 blades. Depending on the results of the BSIs, this AD requires either additional BSIs at reduced intervals or replacement of the HPT rotor stage 1 blades. The FAA is issuing this AD to address the unsafe condition on these products. DATES: This AD is effective December 29, 2025. The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of December 29, 2025. The FAA must receive comments on this AD by January 26, 2026. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45 , by any of the following methods: Federal eRulemaking Portal: Go to regulations.gov. …
Citation: 90 FR 57675
